Steering Angle Sensor: Installation
WARNING: This page is about a different car, the 2013 Land Rover LR4, 2012 Land Rover LR4, 2011 Land Rover LR4, and 2010 Land Rover LR4. However, it is still accessible from the selected car via links, so may be relevant.
- Install the steering angle sensor.
- Tighten the Torx screws to 3 Nm (2 lb.ft).
- Connect the steering column intermediate shaft.
- Install the special bolt and tighten the new nut to 22 Nm (16 lb.ft).
- Connect the steering angle sensor electrical connector.
- Install the closing trim panel.
- Connect the electrical connector.
- Secure the clip.
- Tighten the screws.
- Connect the battery ground cable. Refer to Specifications article.
- Initiate a new steering angle sensor using T4.