LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2012 >> LR2 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 130 (Anti-Lock Control - Traction Control) >> Anti-Lock Control - Traction Control >> Removal And Installation >> Rear Wheel Speed Sensor >> Installation

Rear Wheel Speed Sensor: Installation

WARNING: This page is about a different car, the 2012 Land Rover Range Rover Sport and 2011 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.
  1. Make sure the wheel speed sensor location in the wheel knuckle is free of dirt.
  2. Install the wheel speed sensor.
    • Attach the wiring harness to the 4 clips.
  3. Secure the wheel speed sensor to the wheel knuckle.
    • Tighten the bolt to 9 Nm (7 lb.ft).
    • Attach the wiring harness to the clip.
    4. NOTE: Make sure the electrical connector retaining clip is attached to the body wiring harness.
  4. Connect the ABS sensor electrical connector.
    • Attach the wiring harness.
  5. If a new wheel speed sensor has been installed, interrogate the ABS system using T4.
scientia non olet · About LEMON Manuals