Rear Wheel Speed Sensor: Installation
- Make sure the wheel speed sensor location in the wheel knuckle is free of dirt.
- Install the wheel speed sensor.
- Attach the wiring harness to the 4 clips.
- Secure the wheel speed sensor to the wheel knuckle.
- Tighten the bolt to 9 Nm (7 lb.ft).
- Attach the wiring harness to the clip.
- Connect the ABS sensor electrical connector.
- Attach the wiring harness.
- If a new wheel speed sensor has been installed, interrogate the ABS system using T4.
NOTE:
Make sure the electrical connector retaining clip is attached to the body wiring harness.