LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2011 >> LR2 Base >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Automatic Transmission/Transaxle >> Automatic Transmission/Transaxle (Vehicles With: AWF21 6-Speed Automatic Transmission) >> Removal And Installation >> Main Control Valve Body >> Installation

Main Control Valve Body: Installation

    NOTE: Make sure that this component is installed to the noted removal position.
  1. Install the valve body, do not tighten at this stage.
  2. Install the suction cover and new gasket, do not tighten at this stage.
  3. Tighten the bolts in the sequence illustrated.

    Torque: 10 Nm

    GJ0021998
    4. CAUTION: Make sure that the wiring harnesses are correctly located.
  4. Position and connect the wiring harness.
    5. CAUTION: A new O-ring seal is to be installed.
    NOTE: Lubricate the new O ring seal with transmission fluid.
  5. Install the oil temperature sensor.

    Torque: 10

  6. Install the oil pan. See TRANSMISSION FLUID PAN .
  7. Connect the battery ground cable and install the cover. Refer to Specifications .
scientia non olet · About LEMON Manuals