Anti-Lock Brake System (Abs) Module: Installation

Install the ABS module.
- Tighten the 2 ABS module retaining nuts to 8 Nm (6 lb.ft).
- Remove the blanking caps from the ports.
- Tighten the two M10 and three M12 brake tube unions to 15 Nm (11 lb.ft).
- Tighten the M14 brake tube union to 17 Nm (13 lb.ft).
- Connect the electrical connector.
- Remove the ABS module from the mounting bracket.
NOTE: Make sure the ABS module locating grommet is correctly seated in the bracket before installing the ABS module.

NOTE: Make sure the ABS module locating pin is correctly located in the grommet, and the 2 front isolators are fully seated in the bracket slots.
Using T4, bleed the braking system. For additional information, refer to Brake System Bleeding - Vehicles With: Standard Brakes Brake System Bleeding - Vehicles With: High Performance Brakes .
Install the cover.
If a new ABS module has been installed, interrogate the ABS system using T4.