Anti-Lock Brake System (Abs) Module (3.6L (TDV8) Diesel): Removal
CAUTION:
Make sure the ignition switch is in the OFF position.
NOTE:
The hydraulic control unit (HCU) mounted to the Anti-lock Brake System (ABS) module cannot be serviced separately. If the HCU requires replacement, then the ABS module must be replaced as a complete assembly.
- Raise and support the vehicle.
- Disconnect the battery ground cable. Refer to Specifications .
- Disconnect the electrical connector.
- Release the latch.
- Move the electrical connector aside.
- Release the 6 brake fluid lines.
- Position an absorbent cloth to collect fluid spillage.
- Remove the ABS module.
- Loosen but do not remove the 2 nuts.
- Release from the locating grommet.
WARNING:
Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
CAUTION:
Before disconnecting or removing components, make sure the area around the joint faces and connections are clean. Plug open connections to prevent contamination.
NOTE:
Note the fitted position.