Rear Wheel Speed Sensor: Installation
WARNING: This page is about a different car, the 2009 Land Rover Range Rover, 2008 Land Rover Range Rover, and 2007 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.
- Install the rear wheel speed sensor.
- Apply anti-seize compound to the ABS sensor.
- Secure the wiring harness in the clips.
- Tighten the bolt to 8 Nm (6 lb.ft)
- Connect the wheel speed sensor electrical connector.
- Secure the electrical connector clip.
- Close the electrical connector housing.
- Secure the wheel arch liner.
- Tighten the screws.
- Install the wheel and tire.
- Tighten the wheel nuts to 140 Nm (103 lb.ft).
- Using the approved Land Rover diagnostic system, clear the fault codes from the ABS ECU.