Common Specs & Procedures
(FREELANDER) COMMON SPECS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | AIR CONDITIONING | ||
| Torque | 18 Ft. Lbs (25 N.m) | ||
| Axle Nut/Hub Nut | 295 Ft. Lbs. (400 N.m) | ||
| Battery | |||
| Battery Type | Delphi H6 (Sealed For Life) | ||
| Cold Cranking Amps | 75 Amp/Hour | ||
| Brakes | |||
| Bleeding Sequence | |||
| With ABS | N/A | ||
| Without ABS | BLEEDING BRAKE SYSTEM | ||
| Disc Brakes | |||
| Service Specifications | DISC & DRUM | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator Type | Nippon Denso L-Frame | ||
| Torque | N/A | ||
| Drive Belts | |||
| Adjustment | No Adjustment Necessary | ||
| Drive Belt Routing | DRIVE BELTS ROUTING | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | 15 psi (1.1 kg/cm2 ) | ||
| Thermostat R & I | N/A | ||
| Water Pump R & I | N/A | ||
| Engine Mechanical | |||
| Compression | N/A | ||
| Oil Pressure | At 2400 RPM and normal operating temperature, oil pressure should be at 20-30 psi (2.11-2.81 kg/cm2 ). | ||
| Overhaul | OVERHAUL | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flexplate Aligner-To-Crankshaft Bolt | 63 Ft. Lbs. (85 N.m) | ||
| Flexplate-To-Flexplate Aligner Bolt | 33 Ft. Lbs. (45 N.m) | ||
| Flywheel-To-Crankshaft Bolt | 59 Ft. Lbs. (80 N.m) | ||
| Fuel System | |||
| Pressure Specification | 54.7 psi (3.8 bar) (Fuel pressure unregulated) 50.8 psi (3.5 bar) (Fuel pressure regulated by regulator located in fuel pump module) |
||
| Fuel Pressure Test Procedure | N/A | ||
| Fuel Filter Location | N/A | ||
| Fuel Filter R & I | N/A | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | N/A | ||
| Ignition Wires (Routing) | N/A | ||
| Spark Plug | |||
| Type | NLP 100290 | ||
| Gap | 0.037-0.041 (0.95-1.05 mm) | ||
| Torque | 18 Ft. Lbs. (25 N.m) | ||
| Starting | |||
| Starter | Nippon Denso ~ Power output 1.8 kW | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT SPECIFICATIONS | ||
| Torque Specifications | TORQUE SPECIFICATIONS | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 85 Ft. Lbs. (115 N.m) | ||