LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2002 >> Freelander S >> Repair and Diagnosis >> Engine Mechanical >> Mechanical >> 2.5L V6 >> Repairs >> Switch - Oil Pressure >> Installation

Switch - Oil Pressure: Installation

  1. Ensure oil pressure switch and mating face is clean.
  2. Fit oil pressure switch using a new sealing washer and tighten to 14 Nm (10 ft. lbs.).
  3. Connect multiplug to oil pressure switch.
  4. Remove oil container from underneath of engine.
  5. Fit splash shield and secure with bolts.
  6. Fit right road wheel and tighten nuts to 115 Nm (85 ft. lbs.).
  7. Fit underbelly panel.
  8. Check engine oil level, top-up if necessary. See ENGINE OIL AND FILTER - KV6 .
  9. Connect battery earth lead. See DISCONNECT/CONNECT .
scientia non olet · About LEMON Manuals