LEMON Manuals: Even more car manuals for everyone
Home >> Land Rover >> 2000 >> Discovery >> Repair and Diagnosis >> Transmission >> Automatic Trans >> Automatic Transmission - Servicing >> Removal & Installation >> Center Console >> Installation

Center Console: Installation

CAUTION: When installing gear selector knob, ensure transmission selector is in park, or selector rod will be damaged. See Land Rover TSB TA03 4401 dated April 23, 2003: CORRECT INSTALLATION OF A/T SELECTOR KNOB .
  1. Install and secure cigar lighter body to console. Install lid to console and secure with screws. Install console. Connect connector and bulb to cigar lighter. Install center console to fascia. Install 2 bolts securing rear of console to transmission tunnel. Connect connector to seat switches. Install switches to console. Move hand brake to lowered position. Install cable to hand brake and secure with clevis pin and clip. Install hand brake gaiter to console. Install bolts securing forward edge of console to transmission tunnel.
  2. On vehicles equipped with veneer trim, position veneered console cover and connect connector to switch pack. Install cigar lighter element and secure veneered console cover to console. On vehicles equipped with base trim, connect connector to switch pack. Install switch pack to console and secure with screws.
  3. On vehicles equipped with base trim, install cover plate to switch pack, and rubber mat to console. On all vehicles, install transfer box gaiter and knob to lever. Secure transfer box gaiter to console. Connect connector to selector panel, install and secure panel to center console. Install spacer and knob to gear selector lever. On 2003-2004 vehicles, install both center console cup holders.
scientia non olet · About LEMON Manuals