Common Specs & Procedures
SORENTO (PHEV) COMMON SPECS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SPECIFICATION | ||
| Torque | TIGHTENING TORQUE | ||
| Axle Nut/Hub Nut | |||
| Front | 294.2-313.8 N.m (30.0-32.0 kgf/cm2 , 217.0-231.5 lb. ft.) | ||
| Rear | 294.2-313.8 N.m (30.0-32.0 kgf/cm2 , 217.0-231.5 lb. ft.) | ||
| Battery | |||
| 1.6L | AUXILIARY BATTERY | ||
| Brakes | |||
| Bleeding Sequence | Refer to BRAKE BLEEDING PROCEDURES . | ||
| Disc Brakes | |||
| Service Specifications | SPECIFICATIONS | ||
| Torque | TIGHTENING TORQUE . | ||
| Drum Brakes | |||
| Service Specifications | N/A | ||
| Torque | N/A | ||
| Charging | |||
| Generator | |||
| 1.6L | SPECIFICATION | ||
| Torque | |||
| 1.6L | N/A | ||
| Drive Belts | |||
| Adjustment | |||
| 1.6L | REMOVAL AND INSTALLATION | ||
| Drive Belt Routing | |||
| 1.6L | Refer to Drive Belt figure under REMOVAL AND INSTALLATION . | ||
| Engine Cooling | |||
| General Service Specifications | |||
| 1.6L | Refer to Cooling System under SPECIFICATIONS . | ||
| Radiator Cap Pressure | 93.16-122.58 kPa (0.95-1.25 kgf/cm2 , 13.51-17.78 psi) | ||
| Thermostat R & I | |||
| 1.6L | INTEGRATED THERMAL MANAGEMENT MODULE (ITM) | ||
| Water Pump R & I | |||
| 1.6L | WATER PUMP or ELECTRIC WATER PUMP (EWP) | ||
| Engine Mechanical | |||
| 1.6L | |||
| Compression | COMPRESSION TEST | ||
| Oil Pressure | 100 kPa (1.0 kgf/cm2 , 14.5 psi) or above at 1, 000 RPM and oil temperature (oil pan): 110±2°C (230±35.6°F) | ||
| Overhaul | SPECIFICATION | ||
| Torque | TIGHTENING TORQUE | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE/FLUIDS tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flex Plate/Drive Plate Torque (Torsion Damper) | |||
| 1.6L | 71.6-75.5 N.m (53-55.7 ft. lbs.) | ||
| Fuel System | |||
| Pressure Specification (Low Pressure Fuel Line) | 480 - 520 kPa (4.9 - 5.3 kgf/cm2 , 69.6 - 75.4 psi) | ||
| Fuel Pressure Test Procedure | |||
| 1.6L | FUEL PRESSURE TEST | ||
| Fuel Filter Location | Fuel filter is part of fuel pump module. | ||
| Fuel Filter R & I | |||
| 1.6L | FUEL FILTER | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | |||
| 1.6L | Coil On Plug. | ||
| Ignition Wires (Routing) | Coil On Plug: | ||
| Spark Plug | |||
| 1.6L - Type: SILZKR8J8GS | |||
| Gap | 0.7-0.8 mm (0.027-0.031 in.) | ||
| Torque | 14.7-24.5 N.m (1.5-2.5 kgf/cm2 , 10.9-18.0 lb. ft.) | ||
| Starting | |||
| Starter | |||
| 1.6L | HYBRID STARTER GENERATOR (HSG) | ||
| Torque | Refer to REMOVAL procedures | ||
| Wheel Alignment | |||
| Adjustment Specifications | Refer to WHEEL ALIGNMENT . | ||
| Torque | TIGHTENING TORQUE | ||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 107.9-127.5 N.m (11.0-13.0 kgf/cm2 , 79.6 - 94.0 lb. ft.) | ||