LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2023 >> Stinger GT-Line, RWD >> Repair and Diagnosis >> Engine Performance >> Fuel Delivery >> Fuel Delivery System - 2.5L >> Injector >> Repair Procedures >> Replacement

Repair Procedures: Replacement

NOTE: The combustion seal must be replaced with the following procedure to prevent oil leak or leakage.
  1. Remove the combustion seal (A).
    G14990969Courtesy of KIA MOTORS AMERICA, INC.
    NOTE: Be careful not to damage the injector when removing the combustion seal.
  2. Brush off the dirt on the surface of the injector with the ring off, then wipe off.
  3. Install the combustion seal by using a SST (09353 - 2B000).
    1. Install the seal mounting guide (B) to injector tip (A).
      G14990970Courtesy of KIA MOTORS AMERICA, INC.
    2. Install the combustion seal (A) to the seal mounting guide.
      G14990971Courtesy of KIA MOTORS AMERICA, INC.
    3. Install the rubber ring (A) to the mounting guide.
      G14990972Courtesy of KIA MOTORS AMERICA, INC.
    4. Push the combustion seal (A) in the "A" direction of the installer, then change the direction "B" and push it into the combustion seal mount.
      G14990973Courtesy of KIA MOTORS AMERICA, INC.
      G14990974Courtesy of KIA MOTORS AMERICA, INC.
    5. Install the presser (A), rotate it 3 to 4 times from side to side and remove it.
      G14990975Courtesy of KIA MOTORS AMERICA, INC.
    6. Check the installation condition of combustion seal (A).
    G14990976Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About LEMON Manuals