Monitor KDS Data

Inspection Condition	Inspection Procedure	Reference
1. Ignition "ON", engine "OFF".	Connect KDS to Data Link Connector (DLC). Perform "Vehicle S/W Management" of concerned component with KDS.	Fig.1 to 2

Courtesy of KIA MOTORS AMERICA, INC.

Fig.1) Select "SMK Status Information" in "Vehicle S/W Management".

Courtesy of KIA MOTORS AMERICA, INC.

Fig.2) Displays number of registered key and learning status.

Good

Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
Repair or replace as necessary and Go to "VERIFICATION OF REPAIR " procedure.

No Good