Component Inspection

Inspection Condition	Inspection Procedure	Reference
Ignition "ON".	Ignition "OFF". Shift lever position "P". Engine "ON". Connect KDS to "Data Link Connector (DLC)". Using a KDS, check DTC. Using a KDS, clear stored DTC. Operate the vehicle within "DTC Detecting Condition" in "General Information". Select "Diagnostic Trouble Codes (DTC)" mode again.	-

Good

Go to "VERIFICATION OF REPAIR" procedure.
If symptoms continue to occur, replace the IBU or SCU and Go to "VERIFICATION OF REPAIR" procedure.

No Good

If symptoms continue to occur, replace the IBU or SCU and Go to "VERIFICATION OF REPAIR" procedure.