Repair procedures: Inspection
WARNING: This page is about a different variant/trim than selected.
- Connect the KDS on the Data Link Connector (DLC).
- Switch "ON" the ignition.
- Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
| Accelerator Position |
Output Voltage (V) [Vref = 5V] |
| APS1 |
APS2 |
| C.T |
0.7 - 0.8 |
0.33 - 0.43 |
| W.O.T |
3.98 - 4.22 |
1.93 - 2.17 |