Injector Resistance Inspection
| Inspection Procedure |
|---|
| 1. Measure the injector resistance. ■Specification : Approx. 1.425 - 1.575? at 20°C(68°F) (GDI) ■Specification : Approx. 11.4 - 12.6? at 20°C(68°F) (MPI) 2. Is the measured value within specifications |
Good
• Go to "Compression Pressure Inspection "procedure.
No Good
• Check injector for contamination, deterioration, or damage. Substitute with a known-good injector and check for proper operation. If the problem is corrected, replace injector and then go to "Verification Of Repair "procedure.