Component Inspection

Inspection Procedure 

■ Tooth Error Correction (TEC) learning

1. Perform TEC learning according to procedure.
   • TEC learning method
   • TEC learning will be completed with fuel cut in a range of over 2, 000RPM for more than 10s
2. Start the engine.
3. Operate the vehicle within conditions for setting DTC in general information.

■ Visual check CKPS and target wheel

1. Ignition "OFF".
2. Visually check to see if the CKPS is loose or target wheel is deformed or damaged.

   Good 

   • Go to "VERIFICATION OF REPAIR " procedure.

   No Good 

   • Carefully re-do this troubleshooting guide steps.
   • If problem still occurs, replace ECM and then go to "VERIFICATION OF REPAIR " procedure.