Common Specs & Procedures
RIO COMMON SPECS & PROCEDURES
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | SPECIFICATIONS | ||
| Torque | TIGHTENING TORQUE | ||
| Axle Nut/Hub Nut | 202.5 - 217.0 ft. lbs. (274.6 - 294.2 N.m) | ||
| Battery | BATTERY | ||
| Brakes | |||
| Bleeding Sequence | BRAKE SYSTEM BLEEDING | ||
| Disc Brakes | SPECIFICATIONS | ||
| Drum Brakes | SPECIFICATIONS | ||
| Torque | |||
| Front | Refer to TIGHTENING TORQUE . | ||
| Rear | Refer to TIGHTENING TORQUE . | ||
| Charging | |||
| Generator | Refer to ALTERNATOR . | ||
| Torque | Refer to TIGHTENING TORQUE | ||
| Drive Belts | |||
| Adjustment | Automatic Tensioner | ||
| Belt Routing | Refer to "Engine Drive Belt Routing Diagram" figure under REMOVAL AND INSTALLATION | ||
| Engine Cooling | |||
| General Service Specifications | See Cooling System in GENERAL INFORMATION table under SPECIFICATIONS . | ||
| Radiator Cap Pressure | 13.51-17.78 psi | ||
| Thermostat R & I | INTEGRATED THERMAL MANAGEMENT MODULE (ITM) | ||
| Water Pump R & I | WATER PUMP | ||
| Engine Mechanical | |||
| Compression | COMPRESSION TEST | ||
| Oil Pressure | 117.6 kPa (1.2 kg/cm2 , 17.0 psi) or above at 1000 RPM with Oil temperature in oil pan: 110±2°C (230± 36°F). | ||
| Overhaul | SPECIFICATIONS . | ||
| Torque | TIGHTENING TORQUE | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. From within Manager or Service Writer, click the "30/60/90 Interval" or "Maint." button. | ||
| Flywheel/Flexplate Torque | 52.8-55.7 ft. lbs. (71.5-75.5 N.m) | ||
| Fuel System | |||
| Fuel Filter Location | Fuel filter is part of fuel pump. | ||
| Fuel Filter R & I | Refer to FUEL FILTER . | ||
| Pressure Specification | 323 - 363 kPa (3.29 - 3.70 kgf/cm2 , 46.84 - 52.64 psi) | ||
| Fuel Pressure Test Procedure | FUEL PRESSURE TEST | ||
| Fuel Pressure Release Procedure | RELEASE RESIDUAL PRESSURE IN FUEL LINE | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | N/A | ||
| Ignition Wires (Routing) | N/A | ||
| Spark Plugs | SILZKR7E9, Gap: 0.8 - 0.9 mm, Tightening torque: 10.8 - 18.0 lb.ft | ||
| Starting | |||
| Starter | STARTER | ||
| Torque | 36.2-47.0 ft. lbs. (49.0-63.7 N.m) | ||
| Wheel Alignment | |||
| Adjustment Specifications | WHEEL ALIGNMENT | ||
| Torque | TIGHTENING TORQUE | ||
| Wheel & Tire | |||
| Lug Nut Torque | 79.6 - 94.0 ft. lbs. (107.9 - 127.5 N.m) | ||