Repair Procedures: Installation
WARNING: This page is about a different variant/trim than selected.
CAUTION:
Do not turn the ignition switch ON and do not connect the battery terminal while replacing the front impact sensor.
- Install the new front impact sensor.
- Tighten the front impact sensor mounting bolt.
Tightening torque:
7.0 - 11.0 N.m (0.7 - 1.1 kgf.m, 5.1 - 8.1 lb.ft)
- Connect the front impact sensor.
- Reconnect the battery negative terminal.
- After installing the Front Impact Sensor, confirm proper system operation:
- Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.