LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2020 >> Optima Plug-In Hybrid EX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 103 (Body Control Module Diagnosis (HEV)) >> DTC B1609-00: CAN Time-Out SJB, FSJB >> Wiring Inspection >> CAN Communication Line Inspection

CAN Communication Line Inspection

WARNING: This page is about a different variant/trim than selected.
  1. Disconnect "BCM" connector and "IGPM" connector.
  2. Ignition "ON", Engine "OFF".
  3. Perform "Oscilloscope" procedure as below.
  4. Measure the resistance between "B_CAN High" terminal (PIN No. 21) of "BCM" harness connector and "B_CAN High" terminal (PIN No. 12) of IGPM harness connector.
  5. Measure the resistance between "B_CAN Low" terminal (PIN No. 20) of "BCM" harness connector and "B_CAN Low" terminal (PIN No. 11) of IGPM harness connector.

    Specification:  Below approx. 1Ω

  6. Is the measured resistance within specifications?

    YES 

    • Fault is intermittent caused by poor contact in IGPM connector.
    • Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage.
    • Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.

    NO 

scientia non olet · About LEMON Manuals