Repair Procedures: Installation
WARNING: This page is about a different variant/trim than selected.
NOTE:
- Install the component with the specified torques.
- Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
- Apply the engine coolant to the O-ring.
- Insert the sensor in the installation hole and be careful not to damage.
- Install in the reverse order of removal.
Engine Coolant Temperature Sensor:
29.4 - 39.2 N.m (3.0 - 4.0 kgf.m, 21.7 - 28.9 lb.ft)