Signal Circuit Inspection
- Ignition "OFF".
- Disconnect Battery (-) terminal.
- Refer to REMOVAL , disconnect MTS Module and GPS Antenna Connector.
- Measure resistance between Pin No. 1 (GPS) terminal of MTS Module harness connector and Pin No. 1 (GPS) terminal of GPS Antenna harness connector.
Specification: Approx. Below 1 Ω
- Is measured value within specification?
YES
- Go to "Component Inspection " procedure.
NO
- Repair open in signal circuit between GPS Antenna and MTS Module and then go to "Verification Of Vehicle Repair " procedure.