LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2019 >> Sorento L >> Repair and Diagnosis >> External Pages >> Different car >> Section 6 (Supplemental Restraint System Control Module (SRSCM) And Sensors) >> SRS Control Module (SRSCM) >> Repair Procedures >> Removal

Repair Procedures: Removal

WARNING: This page is about a different car, the 2020 Kia Sorento. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least thirty seconds before beginning to work.
  3. Remove the floor console.

    (Refer to Body - "FLOOR CONSOLE ")

  4. Remove the rear air vent duct (A).
    G12858611Courtesy of KIA MOTORS AMERICA, INC.
  5. Pull up the lock of the SRSCM connector, and then disconnect the connector (A).
    G12858612Courtesy of KIA MOTORS AMERICA, INC.
  6. Remove three (3) SRSCM mounting bolts from the SRSCM, and then remove the SRSCM.
    CAUTION: You must remove or install SRSCM or other SRS components with the ignition switch OFF to avoid accidental airbag deployment.
scientia non olet · About LEMON Manuals