Repair Procedures: Installation

WARNING: This page is about a different car, the 2020 Kia Sorento. However, it is still accessible from the selected car via links, so may be relevant.

Install the brake pedal assembly in dash panel.

Courtesy of KIA MOTORS AMERICA, INC.
Pre-tighten the bracket fixing bolt (B) in dash panel.

Courtesy of KIA MOTORS AMERICA, INC.
Install the brake booster and brake pedal member fixing nut (A) securely.
Tightening torque:

9.8 - 14.7 N.m (1.0 - 1.5 kgf.m, 7.2 - 10.8 lb.ft)

Courtesy of KIA MOTORS AMERICA, INC.
Tighten the bolt (B) securely in dash panel.
Tightening torque:

16.7 - 25.5 N.m (1.7 - 2.6 kgf.m, 12.3 - 18.8 lb.ft)

Courtesy of KIA MOTORS AMERICA, INC.
Install the snap pin (A) and clevis pin (B).

Courtesy of KIA MOTORS AMERICA, INC.
CAUTION:
- Before installing the pin, apply grease to the clevis pin.
- Use a new snap pin whenever installing.
Install the brake switch securely.
Connect the brake switch connector (A).

Courtesy of KIA MOTORS AMERICA, INC.
Adjust the brake pedal height and free play.
Check the brake pedal operation after installing the brake pedal.
Install the steering column shaft assembly.
Install the shower duct (A).

Courtesy of KIA MOTORS AMERICA, INC.
Install the reinforcing panel and crash pad lower panel.
Reconnect the battery negative cable.