CAN Register And Communication Line Inspection 1
WARNING: This page is about a different variant/trim than selected.
- Ignition "OFF".
- Connect all module connectors in proper locations.
- Measure resistance between Pin No. 13 (High) and Pin No. 14 (Low) terminals of IGPM.
Specification: Approx. 60Ω
- Is the measured resistance within specification?
YES
- Check module connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF REPAIR " procedure.
- Go to CAN Register And Communication Line Inspection 2 procedure.
NO
- If the measured value is out of specification, repair or replace 120Ω CAN register (Inside of PCM and IGPM) and then, go to "VERIFICATION OF REPAIR " procedure.
- If the measured value is lower than 10Ω, repair or replace CAN High and CAN Low are short each other. And then, go to "VERIFICATION OF REPAIR " procedure.
- If the measured value is lower than 10Ω, repair or replace CAN High and CAN Low are short each other. And then, go to "VERIFICATION OF REPAIR " procedure.
- Go to CAN Register And Communication Line Inspection 2 procedure.