Ground Circuit Inspection
WARNING: This page is about a different variant/trim than selected.
- Ignition "OFF".
- Disconnect Battery (-) terminal.
- Refer to RAIN SENSOR "service information" and disconnect Rain Sensor connector.
- Measure resistance between Pin No. 3 (Ground) terminal of Rain Sensor harness connector and chassis ground.
Specification: Approx. below 1Ω
- Is the measured value within specification?
YES
- Go to "LIN COMMUNICATION LINE INSPECTION " procedure.
NO
- Repair open or short in power circuit between Rain Sensor and Chassis ground and then go to "VERIFICATION OF REPAIR " procedure.