Monitor KDS/GDS Data
WARNING: This page is about a different car, the 2017 Kia Optima. However, it is still accessible from the selected car via links, so may be relevant.
- Ignition "OFF"
- Connect KDS/GDS to Data Link Connector (DLC).
- Ignition "ON" & Engine "ON"
- Monitor "Hand Position Driving", "Country Code" and "Vehicle transmission type" in "Current Data"
with KDS/GDS.
Specification : Refer to Figure below
- Is the parameter displayed within specification?
YES
- Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
- Repair or replace as necessary and then go to "Verification Of REPAIR " procedure.
NO
- Go to "Wiring Inspection " procedure.