Control (Low) Circuit Inspection
- Ignition "OFF".
- Disconnect Battery (-) terminal.
- Refer to "FUEL PRESSURE REGULATOR and ENGINE CONTROL MODULE (ECM) " and disconnect Fuel Pressure Regulator and PCM connector.
- Measure resistance between Pin No. 1 (Low) terminal of Fuel Pressure Regulator harness connector and Pin No. 90 (Low) terminal of ECM/PCM harness connector.
Specification: Approx. below 1 Ω
- Is the measured value within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair open or short in control (High) circuit between Fuel Pressure Regulator and PCM and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.