LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2019 >> Niro Plug-In Hybrid EX >> Repair and Diagnosis >> External Pages >> Different car >> Section 32 (Supplemental Restraint System Control Module (SRSCM) And Sensors (PHEV)) >> Occupant Classification System (OCS) >> Repair Procedures >> Installation >> Occupant Classification System (OCS) Unit

Occupant Classification System (OCS) Unit

WARNING: This page is about a different car, the 2018 Hyundai Ioniq. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the occupant classification system unit on the Front seat track assembly.
  2. Connect the occupant classification system unit connector.
  3. Install the front passenger seat assembly.

    (Refer to Body - "FRONT SEAT ASSEMBLY ")

  4. Reconnect the battery negative cable.
  5. After installing the occupant classification system, confirm proper system operation.
    NOTE:
    • Turn the ignition switch ON the SRS indicator should be turned on for about six seconds and then go off.
    • Telltale lamp will turn on for 4 seconds and be turned off for 3 seconds. After the 7 seconds, it shall remain off if the OCS does not require suppression and the passenger airbag is enabled.
    • Be sure to perform OCS reset with GDS after replacing OCS unit.
scientia non olet · About LEMON Manuals