Blind Spot Detection DTCS: Left
BLIND SPOT DETECTION (LEFT) DIAGNOSTIC TROUBLE CODE IDENTIFICATION
| DTC | Description |
|---|---|
| DTC C1101 | 17: Battery Voltage High |
| DTC C1102 | 16: Battery Voltage Low |
| DTC C120A | 11: LED Right Circuit Short to Ground |
| DTC C120B | 15: LED Right Circuit Short to Battery or Open |
| DTC C120C | 11: LED Left Circuit Short to Ground |
| DTC C120D | 15: LED Left Circuit Short to Battery or Open |
| DTC C1501 | 01: Switch Failure |
| DTC C160A | 88: BSD Local CAN Bus Off |
| DTC C1612 | 87: CAN Time-out TCU |
| DTC C1614 | 87: CAN time-out HCU/VCU/FCU |
| DTC C1616 | 88: CAN Bus OFF (C-CAN) |
| DTC C1625 | 87: CAN Time-out ABS/ESC (ESP) |
| DTC C1628 | 87: CAN Time-out Cluster |
| DTC C1633 | 81: Cluster Invalid Displayed Speed |
| DTC C1646 | 81: CAN Message Failure - TCU |
| DTC C1671 | 81: Signal Yaw Rate or Acceleration AX or Acceleration AY or Brake Pressure State not valid |
| DTC C1675 | 81: Signal WHEEL_FL or WHEEL_FR or WHEEL_RL or WHEEL_RR not Valid |
| DTC C170A | 11: Activation Switch LED Circuit short to ground |
| DTC C170B | 12: Activation Switch LED Circuit short to battery or open |
| DTC C170C | 04: ECU Hardware error (REAR RIGHT) |
| DTC C170D | 04: ECU Hardware error (REAR LEFT) |
| DTC C1743 | 42: Software version LH/RH unmatching |
| DTC C1812 | 87: CAN Time-out Gateway |
| DTC C1816 | 87: CAN time-out SJB |
| DTC C2702 | 54: Control Module Missing Calibration |
| DTC C2703 | 54: Control Module Slave Missing Calibration |