LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2019 >> Forte FE, Standard Trans >> Repair and Diagnosis >> External Pages >> Different car >> Section 71 (Body Control Module Diagnosis) >> DTC B1629-00: LIN Channel1 Reception Error >> Wiring Inspection >> Power Circuit Inspection

Power Circuit Inspection

WARNING: This page is about a different car, the 2019 Kia Soul EV. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ignition "OFF"
  2. Refer to "REMOVAL " and disconnect Front & Rear PAS Sensor connector.
  3. Ignition "ON"
  4. Measure voltage between Pin No. 6 (Power) terminal of each Front & Rear PAS sensor harness connector and chassis ground.

    Specification:  Approx. 12 V

  5. Is measured value within specification?

    YES 

    NO 

    • Repair open or short in power circuit between concerned Front & Rear PAS Sensor and Battery and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.
scientia non olet · About LEMON Manuals