LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2018 >> Soul Base, Standard Trans >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 13 (Engine Control System - 1.6L T) >> ETC (Electronic Throttle Control) System >> Repair Procedures >> Adjustment

Repair Procedures: Adjustment

WARNING: This page is about a different variant/trim than selected.

ETC module learning procedure 

Be sure to perform the ETC module learning procedure when replacing or re-installing the ETC module.

  1. Wait for 1 minute with the ignition switch ON.
  2. Start the engine and hold the idle status for 15 minutes.
  3. Waif for 1 minute with the ignition switch OFF.
  4. Restart the engine, check that the idle speed is stable.
    NOTE: If not performing the ETC module learning procedure after replacing or re-installing, MIL illumination with DTCs might occur.
scientia non olet · About LEMON Manuals