Repair Procedures: Disassembly

WARNING: This page is about a different variant/trim than selected.

Disconnect the M-terminal (A) on the magnet switch assembly.

Fig 1: Locating M-Terminal On Magnet Switch Assembly
Courtesy of KIA MOTORS AMERICA, INC.
After loosening the 2 screws (A), detach the magnet switch assembly (B).

Fig 2: Locating Magnet Switch Assembly And Screws
Courtesy of KIA MOTORS AMERICA, INC.
Loosen the brush holder mounting screws (A) and the trough bolts (B).

Fig 3: Locating Brush Holder Mounting Screws And Trough Bolts
Courtesy of KIA MOTORS AMERICA, INC.
Remove the rear bracket assembly (A) and brush holder assembly (B).

Fig 4: Locating Rear Bracket Assembly And Brush Holder Assembly
Courtesy of KIA MOTORS AMERICA, INC.
Remove the yoke assembly (A).

Fig 5: Locating Yoke Assembly
Courtesy of KIA MOTORS AMERICA, INC.
Remove the packing (A), lever plate (B), lever (C), armature assembly (D).

Fig 6: Locating Packing, Lever Plate, Lever And Armature Assembly
Courtesy of KIA MOTORS AMERICA, INC.

NOTE: Beware the direction of lever (A).

Fig 7: Locating Lever
Courtesy of KIA MOTORS AMERICA, INC.
Press the stopper (A) using a socket (B).

Fig 8: Pressing Stopper Using Socket
Courtesy of KIA MOTORS AMERICA, INC.
After removing the stop ring (A) using stopper pliers (B).

Fig 9: Removing Stop Ring Using Stopper Pliers
Courtesy of KIA MOTORS AMERICA, INC.
Remove the stop ring (B), stopper (A), over-running clutch (C) and armature (D).

Fig 10: Locating Stop Ring, Stopper And Overrunning Clutch And Armature
Courtesy of KIA MOTORS AMERICA, INC.

Information
- Using a suitable pulling tool (A), pull the over-running clutch stopper (C) over the stop ring (B).
Fig 11: Pulling Overrunning Clutch Stopper Over Stop Ring Using Suitable Pulling Tool
Courtesy of KIA MOTORS AMERICA, INC.