Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.

Fig 1: Locating Heated Oxygen Sensor (Bank 1/Sensor 1)

Courtesy of KIA MOTORS AMERICA, INC.

NOTE:

Install the component to the specified torques.
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
DO NOT use a cleaner, spray, or grease to sensing element and connector of the sensor as oil substance may cause malfunction to the sensor performance.
Sensor and its wiring may be damaged in case of contacting with the exhaust system (Exhaust Manifold, Catalytic Converter, and so on).

Install in the reverse order of removal.
Heated oxygen sensor:

39.2 ~ 49.1 N.m (4.0 ~ 5.0 kgf.m, 28.9 ~ 36.2 lb-ft)