Buzzer Operation Mode

WARNING: This page is about a different car, the 2017 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.

Operation	Switch Input	Buzzer	Hazard Lamp*	Comment
Tailgate Start Opening	Overhead Console SW	2	2
	Inner SW	2	2
	Outside Handle SW	2	2
	Smart/Remote Key	2	2
Tailgate Start Closing	Overhead Console SW	2	2
	Inner SW	2	2
	Outside Handle SW	2	2
	Smart/Remote Key	2	2
Direct direction change Close -> Open	Overhead Console SW	2	2
	Inner SW	2	2
	Outside Handle SW	2	2
	Smart/Remote Key	2	2
Garage Position saved	INR SW	2	-	Buzzer confirms "new garage position" saved
Obstacle detection (reverse operation start)		3	-
Smart Tailgate	Single Blinking	1	-
Smart Tailgate	Double Blinking	2	-
During Calibration Run	Continuous On/Off beep		-	Activate buzzer but no Hazard
System Error	-	3	-	PCU/Tailgate antiplay active, Over/Under voltage condition, End position/position error, spindle error, CAN error, switch press while Latch closed when Tailgate open
Tailgate not closed		10	10	Latch Lock switch not present
Max. End Position learned		-	2	Hazard confirms "learning finished"
Max. End Position deleted		1	-	Buzzer confirms "position deleted"
Car moving with open Tailgate		10	-