Repair Procedures: Replacement

WARNING: This page is about a different car, the 2017 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: Put on gloves to protect your hands.

NOTE:

When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
Take care not to bend or scratch the trim and panels.

Using a screwdriver or remover, remove the rear in-car sensor (A).

Fig 1: Locating Rear In-Car Sensor
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the rear in-car sensor connector (A).

Fig 2: Locating Rear In-Car Sensor Connector
Courtesy of KIA MOTORS AMERICA, INC.
Install in the reverse order of removal.
Information

Make sure that the connectors are plugged in properly.