ECM Neutral Mode procedure

• After replacing the ECM of the vehicle with the immobilizer, the following procedure must be performed.

  [If installing a used ECM]

  1. Perform "ECM NEUTRAL MODE " procedure using GDS. (Refer to REPAIR PROCEDURES "Body Electrical System - "Immobilizer System - Repair procedures")
  2. After finishing "ECM Neutral Mode", perform "Key Teaching" procedure using GDS. (Refer to REPAIR PROCEDURES "Body Electrical System - "Immobilizer System - Repair procedures")

  [If installing a new ECM]

  Perform "Key Teaching" procedure using GDS. (Refer to REPAIR PROCEDURES "Body Electrical System - "Immobilizer System - Repair procedures")

• After replacing the ECM of the vehicle with the smart key system (button start), the following procedure must be performed.

  [If installing a used ECM]

  1. Perform "ECM NEUTRAL MODE " procedure using GDS. (Refer to "Body Electrical System - "Smart key System - Repair procedures")
  2. After finishing "ECM Neutral Mode", turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.

  [If installing a new ECM]

  Turn IGN ON then OFF using the smart key or start button. Then the ECM learns information on the smart key automatically.

TCM learning procedure 

• Perform TCM learning after replacing the PCM.

  (Refer to Automatic Transaxle Control System - "ADJUSTMENT ")

ETC module learning procedure 

• Perform ETC module learning after replacing the ETC module.

  (Refer to Electronic Throttle Control System - "ADJUSTMENT ")