LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2018 >> Sedona EX >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Engine Control System) >> Crankshaft Position Sensor (CKPS) >> Repair procedures >> Removal

Repair procedures: Removal

WARNING: This page is about a different car, the 2018 Kia Cadenza. However, it is still accessible from the selected car via links, so may be relevant.
  1. Switch "OFF" the ignition and disconnect the negative (-) battery terminal.
  2. Remove the air cleaner assembly.

    (Refer to Engine Mechanical System - "AIR CLEANER ")

  3. Disconnect the crankshaft position sensor connector (A).
    Fig 1: Disconnecting Crankshaft Position Sensor Connector
    G12290701Courtesy of KIA MOTORS AMERICA, INC.
  4. Remove the mounting bolt (B), and then vertically remove the sensor from the transaxle housing.

    Crankshaft Position Sensor mounting bolt  :

    6.8 - 9.8 N.m (0.7 - 1.0 kgf.m, 5.0 - 7.2 lb.ft)

Fig 2: Removing Crankshaft Position Sensor Mounting Bolt
G12290702Courtesy of KIA MOTORS AMERICA, INC.
scientia non olet · About LEMON Manuals