Ground Circuit Inspection
- IG "OFF" & Disconnect OTS connector.
- IG "ON".
- Measure voltage between Pin No. 1 (signal) terminal of OTS harness connector and chassis ground. (A)
- Measure voltage between Pin No. 1 (signal) Terminal And Pin No. 1 (ground) terminal of the OTS. (B)
Specification : "A" - "B" = Below 200mV
- Is the measured voltage within specification?
YES
- Go to "COMPONENT INSPECTION " procedure.
NO
- Repair or replace as necessary and then, go to "Verification Of VEHICLE REPAIR " procedure.