Monitor GDS Data
- Connect GDS.
- IG "ON" and engine "OFF".
- Select "Diagnostic Trouble Codes (DTC) " mode.
- After erase DTC
- Is the same DTC occurred again?
YES
- Go to next procedure.
NO
- Fault is intermittent caused by poor contact in the sensor's and/or BCM [PAS (Parking Assist System's)] connector. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and then go to "VERIFICATION OF VEHICLE REPAIR " procedure.