LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2017 >> Soul EV Base >> Repair and Diagnosis >> Brakes >> Traction Control >> Electronic Stability Program (Esp) System >> Yaw-Rate And Lateral 'G' Sensor >> Repair Procedures >> Installation >> Notes

Repair Procedures: Installation: Notes

  1. Remove the ignition key from the vehicle.
  2. Disconnect the battery negative cable and wait for at least three minutes before beginning to work.
  3. Install the SRSCM with the SRSCM mounting bolts.

    Tightening Torque (SRSCM Mounting Bolt): 

    7.8 ~ 9.8 N.m (0.8 ~ 1.0 kgf.m, 5.7 ~ 7.3 lb-ft)

    Fig 1: Locating SRSCM Mounting Bolts
    G11933938Courtesy of KIA MOTORS AMERICA, INC.
    NOTE:
    • Use new mounting bolts when replacing the SRSCM after a collision.
    • When installing the airbag wiring harness, ground points (C) must be installed.
  4. Connect the SRSCM harness connector.
  5. Install the rear heating joint duct.
  6. Install the floor console.

    (Refer to Body - "FLOOR CONSOLE ")

  7. Reconnect the battery negative cable.
  8. After installing the SRSCM, confirm proper system operation:
    • Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.
      CAUTION:
      • SRSCM senses the vehicle rollover. SAB, CAB and BPT may be deployed if SRSCM was shaken up and down or left and right during IGN ON state. For this reason, make sure that the IGN is turned OFF before removing the SRSCM from the vehicle.
      • If the SRSCM is replaced always perform variant coding. Also, perform the lateral G sensor calibration. (Refer to Restraint - "SRS CONTROL MODULE ")
scientia non olet · About LEMON Manuals