LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2017 >> Soul Base, Standard Trans >> Repair and Diagnosis (Single Page) >> Engine Performance >> System >> Engine Control System Diagnosis - 1.6L (1 Of 3) >> DTC P0107: Manifold Absolute Pressure/Barometric Pressure Circuit Low Input >> DTC Inspection >> Monitor KDS/GDS Data

Monitor KDS/GDS Data

  1. Connect KDS/GDS to Data Link Connector (DLC).
  2. Warm up the engine to normal operating temperature.
  3. Check the "Current Data"  for about related DTC with KDS/GDS.
    Fig 1: Scantool Display - Current Data (A: Ignition ON & Engine OFF And B: Cold Engine Condition)
    G12211761Courtesy of KIA MOTORS AMERICA, INC.
    Fig 2: Scantool Display - Current Data (Engine Idle After Warm Up Approx. 2000RPM And During Acceleration)
    G12211762Courtesy of KIA MOTORS AMERICA, INC.
  4. Are the parameters displayed correctly?

    YES 

    • Fault is intermittent caused by poor contact in the sensor's and/or PCM's connector or was repaired and PCM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "Verification of Vehicle Repair " procedure.

    NO 

scientia non olet · About LEMON Manuals