Repair Procedures: Installation

1. Wrap tape around the driveshaft spline (TJ) to prevent damaging the boot.
2. Using the alignment marks (D) made during disassembly as a guide, install the spider assembly (A) and retainer ring (B) on the driveshaft splines (C).
   Fig 1: Locating Alignment Marks On Spider Assembly & Retainer Ring

   Courtesy of KIA MOTORS AMERICA, INC.
   Fig 2: Locating Alignment Marks On Spider Assembly & Driveshaft Splines

   Courtesy of KIA MOTORS AMERICA, INC.
3. Add specified grease to the joint boot as much as it was wiped away at inspection.
4. Install the both boot band.
5. Using the SST (09495-3K000), secure the TJ boot bands.

   Clearance  (A): 2.0 mm (0.0787 in.) or less

   Fig 3: Securing TJ Boot Bands Using SST (09495-3K000)

   Courtesy of KIA MOTORS AMERICA, INC.
6. Install the front driveshaft.

(Refer to "FRONT DRIVESHAFT ")