Repair Procedures: Installation

1. Apply soap powder on the shaft to prevent damaging between the shaft spline and the dynamic damper.
2. Install the dynamic damper.
3. Install the dynamic damper band (A).
4. Using the SST (09495-3K000), secure the TJ boot bands (B).

   Clearance (A):  2.0 mm (0.0787 in.) or less

   Fig 1: Locating Dynamic Damper Band & TJ Boot Bands

   Courtesy of KIA MOTORS AMERICA, INC.
5. Install the TJ joint assembly.

   (Refer to "TJ JOINT ")

6. Install the front driveshaft.

(Refer to "FRONT DRIVESHAFT ")