Confirm Part Inspection: Notes

YES 

• Carefully re-do this troubleshooting guide steps.
• If no problems were found with the circuits or connectors, replace the PCM and go to "VEHICLE S/W MANAGEMENT " procedure.
  CAUTION: When replacing the ECM/PCM, the vehicle equipped with the immobilizer must be performed procedure as below.[In the case of installing used ECM/PCM]
  

  1. Perform "ECM NEUTRAL MODE " procedure with GDS. (Refer to "IMMOBILIZER
  2. After finishing "ECM Neutral mode", perform "Key teaching" procedure with GDS. (Refer to "IMMOBILIZER

  
  [In the case of installing new ECM/PCM]
  Perform "Key teaching" procedure with GDS. (Refer to "IMMOBILIZER
  CAUTION: When replacing the ECM/PCM, the vehicle equipped with the smart key system (Button start) must be performed procedure as below.
  [In the case of installing used ECM/PCM]
  

  1. Perform "ECM NEUTRAL MODE " procedure with GDS. (Refer to "SMART KEY
  2. After finishing "ECM Neutral mode", insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the ECM/PCM learns the smart key information automatically.

  
  [In the case of installing new ECM/PCM]
  Insert the key (or press the start button) and turn it to the IGN ON and OFF position. Then the ECM/PCM learns the smart key information automatically.

NO 

• If no problems were found with the circuits or connectors, Replace the Injector and perform "Resetting Adaptive Values" of Vehicle S/W Management.
• Go to "VERIFICATION OF VEHICLE REPAIR " procedure.
  CAUTION:

  • Install the component with the specified torques.
  • Note that internal damage may occur when the component is dropped or mis-treated.