LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2017 >> Optima Plug-In Hybrid EX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 59 (Driveshaft Assembly (Except HEV)) >> BJ Boot >> Repair Procedures >> Replacement

Repair Procedures: Replacement

WARNING: This page is about a different variant/trim than selected.
  1. Remove the front driveshaft.

    (Refer to Driveshaft Assembly - "Front Driveshaft ")

  2. Remove the TJ joint assembly.

    (Refer to Driveshaft Assembly - "TJ JOINT ")

  3. Remove the Dynamic damper.

    (Refer to Driveshaft Assembly - "DYNAMIC DAMPER ")

  4. Using a plier or flat-tipped (-) screwdriver, remove the BJ boot bands (A).
    Fig 1: Removing BJ Boot Bands Using Plier Or Flat-Tipped (-) Screwdriver
    G12141371Courtesy of KIA MOTORS AMERICA, INC.
  5. Remove the BJ boot.
  6. Install in the reverse order of removal.
    CAUTION:
    • Do not disassemble the BJ assembly.
    • Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease.
    • The boot band should be replaced with a new one.
  7. Check the front alignment.

    (Refer to Suspension System - "FRONT WHEEL ALIGNMENT ")

scientia non olet · About LEMON Manuals