LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2017 >> Optima Plug-In Hybrid EX >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 4 (Supplemental Restraint System Control Module (SRSCM) And Sensors (Except HEV)) >> SRS Control Module (SRSCM) >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different variant/trim than selected.
  1. Remove the Ignition from the vehicle.
  2. Disconnect the battery negative cable and wait for at least thirty seconds before beginning work.
  3. Install the SRSCM with the SRSCM mounting nuts (A) and bolt (B).

    Tightening torque: 

    7.8 - 11.8 N.m (0.8 - 1.2 kgf.m, 5.8 - 8.7 lb.ft)

    Fig 1: Locating Supplemental Restraint System Control Module Nuts And Bolt
    G12141968Courtesy of KIA MOTORS AMERICA, INC.
  4. Connect the SRSCM harness connector.
  5. Install the floor console.

    (Refer to Body (Interior and Exterior) - "FLOOR CONSOLE ")

  6. Reconnect the battery negative cable.
  7. After installing the SRSCM, confirm proper system operation:

    Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.

scientia non olet · About LEMON Manuals