Signal Circuit Inspection
- Ignition "OFF" and disconnect A/C pressure transducer connector.
- Ignition "ON".
- Measure voltage between Pin No. 2 (Signal) terminal of A/C pressure transducer harness connector and chassis ground.
Specification: Approx. 0V
- Ignition "OFF" and disconnect ECM/PCM connector.
- Measure resistance between Pin No. 2 (Signal) terminal of A/C pressure transducer harness connector and chassis ground.
Specification: ∞ (Infinity)Ω
- Is the measured value within specification?
YES
- go to "Component Inspection " procedure.
NO
- Repair or replace as necessary and then, go to "VERIFICATION OF VEHICLE REPAIR " procedure.