LEMON Manuals: Even more car manuals for everyone
Home >> Kia >> 2017 >> Optima EX >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Brake System (Except HEV)) >> Stop Lamp Switch >> Repair Procedures >> Installation

Repair Procedures: Installation

WARNING: This page is about a different car, the 2018 Kia Optima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Fix the brake pedal arm and insert the brake switch fully until the contact part is invisible.
    Fig 1: Inserting Stop Lamp Switch
    G12142120Courtesy of KIA MOTORS AMERICA, INC.
  2. After inserting, turn the brake switch 45° clockwise, and then assemble locking plate by pushing it.
    Fig 2: Turning Stop Switch
    G12142121Courtesy of KIA MOTORS AMERICA, INC.
  3. Check the gap (A) between brake switch and bracket.

    Stop lamp clearance:  1.0 - 2.0 mm (0.04 - 0.08 in.)

    Fig 3: Checking Gap Between Stop Lamp Switch And Bracket
    G12142122Courtesy of KIA MOTORS AMERICA, INC.
    NOTE: If the gap between stop lamp switch and bracket is not 1.0 - 2.0 mm (0.04 - 0.08 in.), perform the above process again.
  4. Install the brake switch connector (A).
    Fig 4: Locating Brake Switch Connector
    G12142123Courtesy of KIA MOTORS AMERICA, INC.
  5. Install the knee airbag.

    (Refer to Restraint - "KNEE AIRBAG (KAB) MODULE ")

  6. Install the crash pad lower panel.

    (Refer to Body (Interior and Exterior) - "CRASH PAD ")

scientia non olet · About LEMON Manuals