Repair Procedures: Removal

WARNING: This page is about a different car, the 2018 Kia Optima. However, it is still accessible from the selected car via links, so may be relevant.

Disconnect the brake fluid level switch connector, and remove the reservoir cap.
Remove the brake fluid from the master cylinder reservoir with a syringe.
CAUTION: Do not spill brake fluid on the vehicle as it may damage the paint; if brake fluid does contact the paint, wash it off immediately with water.
Remove the wheel & tire.
Tightening torque:

88.3 - 107.9 N.m (9.0 - 11.0 kgf.m, 65.1 - 79.6 lb.ft)

Fig 1: Wheel And Tire
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the brake hose clip (A).
Loosen the tube flare nut (B) and then disconnect the tube.
Tightening torque:

12.7 - 16.7 N.m (1.3 - 1.7 kgf.m, 9.4 - 12.3 lb.ft)

Front

Fig 2: Locating Tube Flare Nut And Tube Flare Nut - Front
Courtesy of KIA MOTORS AMERICA, INC.

Rear

Fig 3: Locating Tube Flare Nut And Tube Flare Nut - Rear
Courtesy of KIA MOTORS AMERICA, INC.
Loosen the brake hose bolt (A) from the caliper and then disconnect the hose.
Front

Fig 4: Locating Brake Hose Bolt - Front
Courtesy of KIA MOTORS AMERICA, INC.

Rear

Fig 5: Locating Brake Hose Bolt - Rear
Courtesy of KIA MOTORS AMERICA, INC.